![]() Note! If you choose to use your DD-WRT router as an access point, you may want to disable the Wireless network in Vilfo. To make future changes in DD-WRT you will need to do so using the IP address assigned to your DD-WRT router by Vilfo. Under Device IP address, enter the IP address of your DD-WRT router that you wrote down previously. Locate your DD-WRT router in the list of devicesĬlick on your DD-WRT router in the list of devices In order to be able to access the DD-WRT user interface after the change has been made, you may need to change the IP address of the DD-WRT router to match that of Vilfo. Step 2: Changing the DD-WRT router IP in Vilfo Following versions are supported: minihotspot (broadcomK26 non-nv60k, non-nv64k), nokaid, standard, big or mega. Regarding router compatibility I can only recommend DD-WRT build 22118 or later (coovachilli based dd-wrt). Under Network Address Server Settings (DHCP), enter the following settings.Ĭonnect a network cable between the LAN port on Vilfo to the WAN port on your DD-WRT router There are some ways to build a captive portal server: 1. Under Network Setup, enable the option Assign WAN Port to Switch By default Vilfo uses 255.255.0.0, if the subnet mask differs from the one shown in Vilfo, enter the new one to match the one Vilfo use To do this, you can go to the router’s IP address which should be 192.168.1.1 in. Subnet Mask: Check that the subnet mask is the same one Vilfo use. Set up the Router With DD-WRT Finally, you are ready to set up your router with its new DD-WRT firmware. Write down the IP-address shown here (By default, 192.168.1.1) ![]() Local IP Address: Verify that the IP address entered here is in the same subnet that Vilfo use. (VERY IMPORTANT as the hotspot doesnt work if internet comes from LAN port). Under Network setup, check the following options: Configure DD-WRT Connect the internet (WAN) port to your modem or existing router. Under WAN Connection Type ➝ Connection Type, select Disabled WiFi Repeaters connect to the Router Wirelessly and Creates a Hotspot on the same channel, This causes interferance and increases lag as well as interference. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |